![]() Interference Waveform Pattern for 5G NR Receiver Test ![]() Interference Waveform Pattern for LTE Receiver Test Common with MG3710A.ĪRB Memory Upgrade 1024 Msample for 1stRFĪdditional Analog Modulation Input for 1st RFĪRB Memory Upgrade 1024 Msample for 2ndRFĪdditional Analog Modulation Input for 2nd RF Remote command: Built-in SCPI, MG3700A/MS269xA/MS2830A compatibility modes.Standard 1000BASE-T, GPIB, and USB interfaces.Opt-050/080 extends to two internal modulation sources (AM/FM/ΦM) and one external modulation source supporting Additional Analog Modulation Input for 1stRF/2ndRF.Synchronized with the signal output timing for configuring an 8x8 MIMO system. MIMO Signal Source: Supports local input īaseband clock, local and trigger signals can be shared between up to four MG3710E units to output phase coherency signals.♦ Frequency Range: 50 MHz to 6 GHz, 10 MHz to 18 GHz, 10 MHz to 26 GHz etc. Supports connection of two USB power sensors max. TD-SCDMA, Fading, Multi-Carrier, DVB-T/H, TDMA Signal generation with waveform generation software (IQproducer)ĥG NR (TDD), 5G NR (FDD), LTE/LTE-Advanced, WLAN 11a/b/g/n/j/p and 11ac, W-CDMA/HSPA, CDMA2000 1圎V-DO.LTE (E-TM1.1 to TM3.3), W-CDMA/HSDPA, GSM/EDGE, CDMA2000 1x/1圎V-DO, Bluetooth, GPS, GLONASS, QZSS, Pre-installed standard waveform patterns.Large 64 Msamples waveform memory with optional expansion to 1024 Msampls.RF Band: Built-in,160 MHz*/120 MHz baseband generator.<600 µs (frequency/amplitude, List/Sweep mode) IQ data generated by general-purpose signal-generation software and converted waveform patterns used by MG3710Eġ00 kHz to 2.7/4/6 GHz (1stRF Opt-032/034/036)ġ00 kHz to 2.7/4/6 GHz (2ndRF Opt-062/064/066).Waveforms generated by IQproducer waveform generation software (sold separately) (MX3701xxA).Optional waveform patterns (sold separately) (MX3700xxA, MX3700xxB, MX3710xxA).The following four types of waveform pattern can be used with the MG3710E Multiple Wanted Signals for LTE-Advanced Carrier Aggregation Testingįor these multi-signal applications, the MG3710E eliminates the cost of extra signal generators, simplifies equipment setup and calibration, streamlines system operations and speeds measurement times.Multiple Wanted Signals for MIMO Testing. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |